Clips to Hold Lumber when using Ramp as Leveler

• 3 Clips per Ramp Required
• May also be known as Dunnage holders
• Three required for each ramp used as a load leveler
• Comes in  6″ wide, for 20K max per axle ramps.
• Required for use atop spacers to protect the aluminum ramp and spread the load
• Converter Stakes are built for standard Stake Pockets 3 3/8" WIDE
• There is a connector piece at the bottom of the Converter stake. It comes in storage mode. To be deployed, it needs to be removed, flipped, re-inserted and locked. Then the converter stake is locked in place inside the trailers stake pocket. To store, repeat the operation in opposite.
• Each Converter Stake is marked "L" or "R" For Left or Right, designated from the perspective of the person sitting on the driver's seat or, put another way, a viewer standing at the rear of the trailer looking toward the Cab side.
• The Converter stakes must be used in pairs of Left and Right.
• The very top of the Converter stake has a single cast piece with a slit. This is to guide the G70 chain through it.
• When the ramp is flipped and inserted down the channels of the converter stake, the wheel surface of the ramp should be facing toward the trailer rear
• Three "H" shaped Lumber Clips per pair of Converter Stakes are necessary to lock the lumber in place
• The Lumber itself is not included

Warranty Policy:

• Warranty General Ramp.pdf