HD Ramps Ramp to Load Leveler Converter Stakes for Step Deck Trailer (Left and Right Hand Side)

• BUILT FOR STANDARD STAKE POCKETS 3 3/8" WIDE
• Holds ramps upright for use as levelers (1 pair required per ramp, 1 left & 1 right).
• Use a chain binder with up to 3/8" chain to securely fasten stakes to trailer stake pockets.
• This converter stake is used with 18" ramps.
• Getting the correct stakes is important. When using spacers, stake height = ramp width + spacer height used.
• Some trailers have a narrow pocket. Measure the stake pocket to be sure to get correctly sized stake inserts.
• Stake inserts are designed to be reversed to allow for up to a 1″ difference in trailer rub rail widths.
• There is a connector piece at the bottom of the Converter stake. It comes in storage mode. To be deployed, it needs to be removed, flipped, re-inserted, and locked. Then the converter stake is locked in place inside the trailer's stake pocket. To store, repeat the operation in the opposite.
• Each Converter Stake is marked "L" or "R" For Left or Right, designated from the perspective of the person sitting on the driver's seat or, put another way, a viewer standing at the rear of the trailer looking toward the Cab side.
• The Converter stakes must be used in pairs of Left and Right.
• The very top of the Converter stake has a single cast piece with a slit. This is to guide the G70 chain through it.
• When the ramp is flipped and inserted down the channels of the converter stake, the wheel surface of the ramp should be facing toward the trailer's rear.
• Three "H" shaped Lumber Clips per pair of Converter Stakes are necessary to lock the lumber in place.
• Additional sizes to accommodate different trailer drops are available upon request; 16″, 19″, 20″, 21″, 22″, 24″, and 26″

Note: Ramps and kits are only compatible with HD Ramps products.