Trailer Stake Pocket D-Ring

5/8" Forged D-Ring, Anchor Dimentions: 5-1/5" Tall from bottom of the mounting plate to the bottom of the anchor 3-1/2" Wide 4-1/4" From bottom of the mounting plate to the top of the pin hole

The D rings are approximately 3 - 3/8" inches in size, and they fit perfectly in the stake pockets on the sides of my flatbed carhauler. However, the front and rear pockets are not square-shaped, so some modification is needed to fit the D rings in them. Please note that this is an issue with the trailer and not with the Mytee D rings themselves.

Yes, they will work fine and also our previous customer confirmed that these D rings effectively secured the John Deere 4052R, which weighs around 4800 lbs, on his 16ft trailer.

These D rings are excellent; they will certainly fit through.

We have the size of pins you need available for purchase either individually or in packs of five or ten, for both types of pins.

Although we do offer bolt on winches, they are not the pocket models. Instead, we carry Movable Bolt-On Winches which are versatile enough to be installed at any point along the trailer side channel.

We offer 1, 2, 4, and 8 packs of our product. Specifically, a 1 pack includes 1 Quantity, a 2 pack includes 2 Quantity, a 4 pack includes 4 Quantity, a 8 pack includes 8 Quantity, and more into 12 pack, 16 pack.

This trailer stake pocket d ring should work well for you, as long as you have a standard size (2" x 4" Stake Pockets) stake pocket. The lower portion of the d ring assembly has holes drilled through it, where you can slide a strong pin below the pocket to hold it in place. If the first hole doesn't provide enough clearance, you can try moving down to the next hole. With this setup, one user was able to securely tie down an 8000# tractor on multiple trips.

They are made over seas

These are imported

"5/8"" Forged D-Ring, Anchor Dimentions:
5-1/5"" Tall from bottom of the mounting plate to the bottom of the anchor
3-1/2"" Wide
4-1/4"" From bottom of the mounting plate to the top of the pin hole"

The 3/8" chain will fit thru a SPDR and or D-ring.

This only has a working load limit of 5400 lbs.  All of our products have been tested and are up to D.O.T standards and codes.

I am sorry but we don't have an option on color for these.

We would only have the standard SPDR.

• Anchor Dimentions:
• 5-1/5" Tall from bottom of the mounting plate to the bottom of the anchor
• 3-1/2" Wide
• 4-1/4" From bottom of the mounting plate to the top of the pin hole

I just measured these so I could tell you for sure and these do measure just under 3-1/2" and under 1-1/2" on the other side.  You should be ok as far as them fitting into your stake pockets.

The dimensions listed are correct online.  You would have to determine if they will fit.  I'm not sure if you meant they are shy of being too small or too large.

The working load limit on these is 5400 lbs.  The maximmum capacity is 16,200 lbs.  You have to make sure you are in compliance with all DOT regulations based on those WLL.  

the measurement from pin to plate is 4 and 1/4 inches

the inside dimension of your pocket should be 1 1/2  x  3 1/2"     and the inside of the d ring is  2" x 2 1/4" 

about 3.25"

Not sure of the pocket size you have but here are the dimentions of the product.

• 2-1/2" x 2-1/2" I.D